Pre-Engineered Metal Buildings Certifications & Appovals
Curvco Steel Buildings are designed to meet the most rigorous seismic, snow and wind load conditions. Extensive engineering calculations and computer simulations have been conducted on Curvco’s building components to verify their maximum load capacities. The Factory then also laboratory tested its pre-engineered metal building steel panels until failure to document their performance. This structural testing was performed by independent laboratories and has been accepted by the US Army Corps of Engineers as validation of the stated properties. The approval and certification process for many countries requires periodic or annual recertifications in order to remain current to the latest amendments in the different building codes.
The list below includes some of the major domestic and international certifications and approvals obtained by our Factory.
* Engineer certified in 50 states to meet IBC (International Building Code) structural building code (STAMPED CERTIFIED DRAWINGS AVAILABLE NATIONWIDE)
* Laboratory tested and certified to meet extreme wind provisions in the Florida building code
FLORIDA PRODUCT APPROVAL CODE NUMBERS:
FBC ORGANIZATION # PDM4001
FL3895 R3 Endwall Panel PBR36x1.25-26 (FBC 2007)
FL11815.1 R1, FL11815.2, FL11815.3, FL1181534 Endwall Panel 24×3.5-18,20,22,23
FL13036.1 Arch Roof Deck Panel (FBC 2007)
CAN/CSA A660 DESIGN AND FABRICATION CERTIFICATION FOR METAL
CWB (CANADIAN WELDING BUREAU) CSA W47.1
EU BUILDING CODE APPROVALS:
B EN 1991-1-3 EUROCODE #1 Snow Loads
BS EN 1991-1-4 EURO CODE #1 Wind Actions
BS EN 1993-1-1 EURO CODE #3 General Rules Buildings
BS EN 1993-1-3 EURO CODE #3 Cold Formed Members and Sheeting
BS EN 1993-1-3-2006 EURO CODE #3 Cold Formed Members and Sheeting
DIN 1055 Design loads
DIN 18 1800 Design-Steel Structures (Appl. Sections)
OSHA SHARP CERTIFICATION – workplace safety
Curvco steel arch building specifications meet the highest standards and are evident in our manufacturing procedures and the structure features.